What should be paid attention to in the application and maintenance of the new tunnel rig?

The new tunnel rig not only needs to pay attention to when it is applied, but also needs to be paid attention to during maintenance. The efficiency of the work of the equipment during the application of maintenance is all directly related. The following are some points that should be paid attention to in the application and maintenance of new tunnel rigs.

　　1. When applying new tunnel rigs, it is necessary to ensure safety. Therefore, such machinery and equipment are very prone to sloshing during application, so everyone must grasp it while working.

　　2 During operation, everyone must remember to adjust the machine equipment and the object to be drilled. This is to ensure that the force is well-balanced so that the drill bit does not occur during the drilling process.

　　3. When drilling the buckle, the drill buckle must not be held by hand, so if a problem occurs in this link, it will cause very serious consequences, so the clamp must be clamped, pressed firmly, When the thickness of the object is thin, the wooden board should be underneath.

　　4. When maintaining a new type of tunnel rig, it is important to check each component to see if it is missing. In addition, the joint pins of each part should also be checked to see if there is any problem with each other;

　　5, followed by a regular inspection of the power head, oil cylinder, drill bit, etc. on time to prevent problems during application, which will affect the normal application of machinery and equipment;

　　6, the drum of the winch for the new tunnel driller, please remember to check, especially for the height of both sides of it must be confirmed, so this is a job that can affect the application of the machine equipment s efficiency;

　　7, do n’t forget to check the electrical system, take a look at the leakage protection equipment, whether the emergency power-off switch is in normal condition, etc.

　　8 In the drilling process, everyone should remember to ensure that iron filings are not handled by hand or gauze. Everyone should use a special brush for cleaning, so as to ensure that they are not used when applying Problems will occur, but also to ensure that the drill bit of the machine equipment will not have problems.

The above is that the new tunnel drilling rig must pay attention to the above problems when it is applied, and should also ensure that the machinery and equipment are cleaned and placed gently after the application is completed to prevent damage to the machinery and equipment. Everyone must pay attention to these issues.